KCleaner 3.8.2.112 not listing file to be deleted

[peterblaise]

KCleaner 3.8.2.112 not listing file to be deleted, shows MB ready to delete, no listing of files.

[Kyle_Katarn]

In simulation mode ?

[peterblaise]

Yes, the sequence is to run [ Simulate ] first to see what's to be deleted, then click [ Clean ] to go ahead.

There is no list of files displayed, only a total megabytes to be cleaned, then clicking [ Clean ] runs and cleans, and displays the megabytes cleaned.

I reverted to KCleaner v3.7.0.107, and it shows the list of files to be deleted fine.

The only difference between KCleaner v3.8 and v3.7 is that v3.8 does not show a list of files, that panel stays blank, and in v3.7 the file list panel populates and shows the files proposed for deletion, otherwise, both versions behave the same.

- - - - - - - - - -

Windows 10 64 Home 19041 191206-1406
HP Stream Laptop 14-cb1xxx, Celeron x2 N4000 @ 2485.86 MHz
BIOS Insyde F.14 06/11/2020
Graphics PCI-Express VGA Controller Intel UHD Graphics 600 Gemini Lake v27.20.100.8681 09/05/2020
Display 1366 x 768 @ 60 Hz 6-bit color depth (!)
DirectX Version 12.0

Wait, what?

6-bit color depth?

I just went to Intel to update the drivers, and now the file list in KCleaner v3.8 is -b-a-a-a-a-c-k- ! ! !

Never mind.

The Intel install is taking forever, the dots are moving so slow, and it still says 6-bit in Windows Settings, perhaps it will show 8-bits or more when I reboot, but I'll post this and return with any news.

Idiopathic, I have no idea what was going wrong or what "fixed" it, other than the report above.

[Kyle_Katarn]

So you confirm that everything is OK now with KCleaner ?